The filling of lubricating oil for linear leadership It is widely known that the smoke and dust resulting from engraving and cutting damaged guides after a certain period of operation. Therefore, the daily maintenance the wizard, it is necessary to bar users.Users should turn off the laser engraving machine and reduce performance, net guides with a net, then do not hesitate to Mull the lubricating oil on the guide rail, tryscroll bar and make sure that the oil is in. Do the slide bar to move the Guide bar after filling oil and install guides first.Don't correct the Guide bar must first install the screws to the correct position and to maintain a snapshot of the ray on the level. Finally, to the consolidation of the tape and insert the rod and install lens and then set the target light X. 2. Sync settings, some of the belt straps on one machine, laser engraving machine, if synchronous belt too free, which will result in the dual images engrave the words, if the synchronous belt is too tight, which will result in the wear of the synchronous belt. After a period of use, edit the tight screws synchronous belt, set the synchronous belt up to the extent that it is appropriate, it is sufficient if it is not double images engraved words and The noise of laser engraving and cutting laser is very low, or you can look to our technology. 3. clean the reflector and focusing mirror After the period of application of laser engraving laser and cnc cutting machine , smoke and dust to the surface of the reflector and the mirror, which will be influence on the engraving and the depth of cut and will also have an impact on the accuracy and engraving. Reflector and focusing mirror should be cleaned PURE alcohol downloads. 4. oil for bearings Laser cnc router is equipped with plenty of sources, in order to maintain good engraving and cutting on the result, which is part of the bearings is again filled with oil on a regular basis. So to maintain the good outcome of engravings, users need to clean up all of the deposits. Wipe the surface of the dust on the bearings with a piece of soft fabric, the movement of dust on the bearings in the first place, and take a piece of injectors and suck on some motor oil inside, then fill in the deposit of pinhead and move at the same time. 5. CO2 tube maintenance Laser engravers using cycle water as the cooling system. As time continues, however, there are some furrings inside the pipe, the engraving machine. In order to make sure that the machine works without problems, users need to a bit of vinegar to the water, which dissolve water stone. Then go to the use of clean water for cleaningthe tube. In this way, laser tubes stay in the best working conditions and allows the machine durability.